Vis detaljer
Veil. monteringstid: 0,15time(r)
Vekt: 0,50 KG
Mål (LxHxB): 15x8x3 cm
Antall pr bil: Antall ukjent
Set includes
- Drill with handle
- Awl with handdle
- 5 rubber cords, each 10 cm long
- Tube of glue (12g)
How to use the kit:
1. Locate the area where the tyre has been punctured.
2. Grease the cutter with the glue provided and drive it into the hole, following the angle of the hole fill it well with glue.
3. Thread the cord onto the awl and bend it in half with the ends up.
4. Apply glue to the cord and use the awl to press it into the hole, following the angle of the previous penetration. With a firm motion, push the awl and cord through the damaged area.
Make sure that the cord goes all the way through the tyre.
Be careful not to pull the entire cord inwards.
The two ends of the cord should protrude approximately 0.5 - 1cm above the tyre tread. Firmly remove the stalk from the tyre (do not twist the stalk inside the tyre when removing it - this may break it).
5. Cut off the two protruding ends of the cord leaving 5mm above the tyre. The cord will flush with the tread surface as you drive.
La vårt BMW spesialiserte verksted montere delene. Vi har ekspertisen og en lav timespris!
ALT TIL BMW & MINI! I vår onlinekatalog finner du ”kun” ca. 27.000 nye og brukte produkter ut av de ca. 500.000 BMW & MINI produktene som vi kan levere, så kontakt oss hvis ikke du finner det du mangler! Husk vi har alltid de laveste priser og det største utvalget! Venligst merk at hvis du har det originale BMW / MINI reservedels-nummeret (11 sifre, evt. bare de siste 7 sifre) – så kan du taste det inn direkte i søkefeltet eller innkjøpskurven og se prisen og evt. bestille det, selvom delen ikke finnes i vår online katalog! Kontakt oss! – på odense@schmiedmann.com